Flexitune

Flexible Fuel Conversion since 2005

How to test injector circuit on Flexitune 2

Ask your questions about Flexitune products and installation.

How to test injector circuit on Flexitune 2

Postby alex » 01 Aug 2011, 12:33

Verify that Flexitune INC-ECU circuit works correctly. Connect a LED to the from +12V to INJ (make sure that the polarity of the LED is correct and a resistor may be needed so the LED does not get over-current). If Flexitune is switched on and you connect ECU to ground for a second the LED (connected to INJ) shall by activated. If the LED is not activated there is something wrong with Flexitune (check components polarity and mountings on the PCB).
alex
 
Posts: 18
Joined: 04 Jul 2011, 14:17

Return to Flexitune F.A.Q.

Who is online

Users browsing this forum: No registered users and 1 guest

cron